photo of
actual

energized
with 12 Volts

FINALLY Someone has come out with an illuminated whip that can
withstand the abuse that QUADS dish out!

We Call it the Luminescent Lighting system!
THIS IS NOT A CHEM-LIGHT of ANY KIND

Our system has been tested in the most extreme conditions. We've run it on the sand dunes, through trails and trees and it still looked brand new! Finally, we started slamming it on the ground.(click to see video!!!!)

Other systems use light bulbs mounted at the top of the flag, others use LED's in a hollow tube, both of these systems have solder joints going up the entire mast and/or fragile tungsten elements inside a thin glass or plastic housing, which break very easily, Hollow tube designs also bend and kink easily, ruining your whip leaving you with an expensive flag that doesn't light up or can't stand tall. Our system uses a solid fiberglass core which won't kink There are NO L.E.D'S OR BULBS TO BREAK! Even bulbs that are "shock resitant" can't compare to our system! In fact, the only thing that runs the length of the pole is a high tensile strength wire that is STRONGER THAN THE FIBERGLASS CORE! Our system has a lifetime measured in the THOUSANDS of hours!

How does it work?
Using the latest technologies that have been perfected for the automotive and industrial lighting industry, we are able to offer a product that is virtually indestructible and perfect for the off-road industry. It's WATER PROOF, CONSUMES VERY LITTLE POWER & IS MAINTENANCE FREE. Our unit uses cutting edge technology to generate a bright glow that is visible for over a 1/4 mile in clear conditions. This product was developed by ATV enthusiasts FOR ATV enthusiasts. The system is coupled to a small inverter, about the size of a quarter, that is waterproof and easily mounted just about anywhere (long leads are provided), even to the flag itself! the inverter runs cool, makes no noise, and uses about 30 milliamps (.03 amps) of power! During the day, use it as a regular flag, Your is UV Resistant! at night, light up the sky and draw a crowd!

Other systems require a constant 12 Volts on the vehicle. While we do offer this same system for ease of installation, we also offer systems that will run on quads that don't have a battery such as the BANSHEE and the TRX450R. We even have a system that runs off a 12 Volt battery pack and is INDIPENDENT OF THE VEHICLE

YOU CAN MOUNT OUR WHIP ON ANYTHING!

QUADS WITH ADDITIONAL LIGHTS ALLREADY INSTALLED CAN RUN OUR LIGHT WITHOUT OVERLOADING THE STATOR BECAUSE IT DRAWS SO LITTLE POWER!

Gone are the days of the Chem-Lite!
If you're like us you've had a chem light taped to the top of your flag at some point, only to have to remove it the next morning because it's dead. Chem lights are great, but their uses are limited and taping them on onto the top of a flag is a pain.

Once the system is installed (Usually takes less than 5 minutes), all you have to do is install your whip like any other whip and connect a plug, you're done! You can even do it easily at night. During the day, just leave it plugged it, even if it's running ALL DAY LONG, it won't burn out! The entire system runs cool and on very little power. Again, it's life is measured in the THOUSANDS of hours!!

Your whip will come ready to install, including detailed instructions, the in the color of your choice, one inverter with attached double-sided super strong 3M Adhesive tape, 2 electrical Scotch locks (for quick installs, soldering recommended), 2 small Zip-style ties to clean up any excess leads and we even include a ring type connector to mount the negative wire to your frame, if you wish!

So order yours today and start lighting up the night with you own !

PLEASE NOTE
will become available over the internet very soon! If you would like to be notified when they are available Please E-MAIL US HERE. We will E-mail you when they are ready for shipping.